WPG Sander Light (Push Version)
How to Use
Please charge Scrubber before first use. USB charging cable needs 5 hours and Quick charger needs 1.3 hours.
Please follow the steps :
Charge till the indicator of charge cable turns green.
Unplug Switch-off plug.
Insert Waterproof Plug into the charging inlet to prevent water seeping.
Press Start-up Button to start up.
Press Speed Button to change rotating speed.
Insert Switch-off Plug after use to extend the batter life.
Light & Ergonomic Design.
Easy To Use.
Hold the center of the main body in your palm and press the start-up button with the second knuckle of your thumb for easy scrubbing and waxing.
*Please ensure to place Attachment at the center of Backing Plate to avoid scratching the cleaned objects.
*Such as 3-inch Backing Plate must be used with 4-inch Polishing Pad, 4-inch Scouring Disc, 3-inch sandpaper, and 3-inch Melamine sponge, etc.
*4-inch Backing Plate must be used with 4-inch sandpaper and 5-inch Scouring disc.
When light Indicator flash or shut down automatically, following conditions are what may be the cause.
If Scrubber is not used for over 2 minutes, it will power off automatically to save battery power.
Low Battery Reminding
Indicator starts flashing from around low 1/5 of battery. Light Indicator will flashing till battery runs out.
Press Speed Button during operation to change rotating speed.
(Red: 150rpm / Orange: 100rpm / Green: 50rpm)
After Scrubber not being used over 2 minutes, just turn it off and on again. Its speed will runs the same as it was selected before.
When rotating speed unstable and different light colors flashing, it indicates the press is overloading. Please reduce pressing force or change the rotating speed to ensure its best efficiency.
Overheat Protection & Motor Jam Protection
If it runs in overheat, light Indicator will be flashing. Please wait till internal temperature drops and light Indicator stops flashing. / If it stops rotating suddenly and light Indicator keeps flashing, its motor may be jammed. Please insert back Switch-off Plug before removing foreign object.
Careful maintenance can extend the service life of WPG Sander Light PV Mutifuction Polishing Scrubber.
After using, please insert Switch-off Plug to extend the battery life. Do not long-term store it in the car or high temperature environment above 122°F (50°C).
The motor transmission shaft hole and the screw joint of accessories can be wiped with lubricant to avoid rust.
Please use clean cloth with neutral detergent to clean off the body simply. Do not use corrosive cleaning agents.